Products > RF Products >

GSM High Selective Repeater

 

MR-HSBGSM60

GSM High Selective Repeater is a high linear repeater which provides high frequency selectivity at low power consumption.
Additional Features:
- Auto Setup
- Overload protection
- Oscillation protection
- High Spectral Purity


MR-HSBGSM60
Specifications:
Electrical
Down LinkUp Link
Frequency range 935 - 960 MHz 890 - 915 MHz
Operational Frequency Band 11.4 MHz; Option -9.1 MHz 11.4 MHz; Option -9.1 MHz
Gain at min. Attenuation, min. 63 dB 60 dB
Output Power @ 1 dB Compression Point 30 dBm 20 dBm
Output Power, min.
Meet Intermodulation Products
ETS 300 609-4/GSM 11.26#6
 17 dBm 13 dBm
FCC -13dBm
24 dBm 18 dBm
Output IP3, min. 40 dBm 33 dBm
Range of ALC Output Power Setting Points 8-23 dBm (up 8 set points) (Other available by request) -
Range of AGC 30 dB
Pass Band Ripple ± 1.5 dB
Pass Band Center Frequency Setting Step 25 KHz
Out of Band Gain, at offset from edges 400 kHz and more Meet ETS 300 609-4/GSM 11.26 #7
Selectivity:
At 1 MHz offset from Pass Band edges, min.
 50 dB 50 dB
Intermodulation Distortion from Out off Pass Band Input Signals
0 dBm 0 dBm
Noise Figure at min. Attenuation, max. 6.5 dB
Protection from Oscillation and Overload Automatic
Impedance 50 Ohm
VSWR, max. 2:1
Propagation Delay, max. 5 µ sec
Input Power, No Damage, max. 10 dBm
Limited Output Power 28 dBm 19 dBm
Biasing 6.7 VDC @ 3.5 A max (Option - 220 VAC/ DC Adapter included)
Mechanical
Dimensions 280x250x65 mm
Weight 2.5 kg
Connectors N-Type, Female
Mount Wall / Ceiling Mount
Environmental
Operating Temperature Range - 10°C to + 50°C
Humidity, min. 95%
Splash, Dust Protected
Service Life > 10 years
NOTE 1 Range of AGC, step 1 dB: The Up Link Gain is always 3 dB lower than the Down Link Gain
NOTE 2 Intermodulation Distortion from Out off Pass Band Input Signals : 2 tones at –30dBm (Down Link), at -40dBm (Up Link), with 1 MHz spacing and 1 MHz and greater Pass Band Offset

MARS reserves the right to make technical changes or modifications to any of its products and specifications without prior notice and without implementing such changes to prior supplied products. Product images are representative and indicative only. Warranty terms and general conditions of sale are applicable on any purchase of any product and are available in the “Policies” section.