Power Amplifiers – Cellular Bands
Specifications: |
||
|---|---|---|
| Electrical | ||
| Standard | IMT2000, UMTS | |
| Frequency range | 2110 - 2170 MHz | |
| Gain | 11 dB | |
| GAIN Flatness, max | ± 0.5 dB | |
| Output Power @ 1 dB Compression Point | + 38 dBm | |
| Output IP3, min. | + 50 dBm | |
| Noise Figure, max. | 5 dB | |
| Impedance | 50 Ohm | |
| VSWR, max. | 2:1 | |
| Biasing | 9 VDC@ 1.2A ( at 30 dBm RF Pout) | |
| Mechanical | ||
| Dimensions | 60 x 50 x 20 mm (Without Heat Sink) | |
| DC Connector | Feed Through | |
| RF Connectors | SMA , Female | |
| Environmental | ||
| Operating Temperature Range | - 20ºC to + 50ºC | |
| Humidity, min. | 95% RH, IEC 60068-2-56 | |
| Splash, Dust | Protected | |
| NOTE 1 | Note: At RF Pout more than 30 dBm a use of a heatsink is highly recommended. Heat sink is not included. | |
MARS reserves the right to make technical changes or modifications to any of its products and specifications without prior notice and without implementing such changes to prior supplied products. Product images are representative and indicative only. Warranty terms and general conditions of sale are applicable on any purchase of any product and are available in the “Policies” section.
Mars Antennas & RF Systems is a leading supplier of specialized antennas and RF sub-systems
http://www.mpccallcenters.com | http://www.messagesplus.com | Answering Service
keywords antenna , embedded , subscriber , sector , base , panel , broadband , internal , yagi , dual band , multi band , in building , indoor , outdoor , omni , directional , GSM , wireless , cellular , BDA , IDEN , UMTS , DECT , ISM , GPS , PCS , WLL , MMDS , amplifier , filter , repeater , splitter , jammer , log periodic , helical , ECM ,
Re-Radiating Systems